Fujitsu PRIMERGY RX2540 M7 Upgrade And Maintenance Manual page 237

▶ Release all HDD/SSD modules and pull them out a few centimeters, see
"Removing a 2.5-inch HDD/SSD module" on page
The HDD/SSD modules need not to be removed. But if you want to
remove them nevertheless, check if all HDD/SSD modules are
uniquely identified so that you can reinsert them into their original
bays.
▶ Release all dummy modules and pull them out a few centimeters, see
"Removing a 2.5-inch HDD/SSD dummy module" on page
Removing the rear 2x 2.5-inch HDD backplane
▶ Disconnect all cables from the rear HDD backplane.
Figure 122: Removing the rear 2x 2.5-inch HDD backplane
▶ Loosen the screw (see circle).
▶ Take out the rear HDD backplane.
RX2540 M7
Hard disk drive (HDD) / solid state disk (SSD)
Upgrade and Maintenance Manual
181.
178.
237