Fujitsu PRIMERGY RX2540 M7 Upgrade And Maintenance Manual page 194

Hard disk drive (HDD) / solid state disk (SSD)
Only for Japan/APAC:
Two foams are attached to the spare part of the HDD backplane to allow
the replacement in any mounting position.
When replacing the HDD backplane, detach the foam according to the
original mounting position.
Figure 91: 8x 2.5-inch HDD backplane with two foams
Preliminary steps
▶
"Locating the defective server" on page
▶ If applicable,
"Removing the front cover with lock" on page
▶
"Shutting down the server" on page
▶
"Disconnecting the power cord" on page
▶
"Getting access to the component" on page
▶ Release all HDD/SSD modules and pull them out a few centimeters, see
"Removing 2.5-inch HDD/SSD modules" on page
The HDD/SSD modules need not to be removed. But if you want to
remove them nevertheless, check if all HDD/SSD modules are
uniquely identified so that you can reinsert them into their original
bays.
▶ Release all dummy modules and pull them out a few centimeters, see
"Removing a 2.5-inch HDD/SSD dummy module" on page
▶
"Removing the fan cage" on page
194
50.
76.
Upgrade and Maintenance Manual
47.
50.
55.
180.
49.
177.
RX2540 M7