Fujitsu PRIMERGY RX2540 M7 Upgrade And Maintenance Manual page 289

Figure 163: Running the GPU cables
▶ Run the GPU cables in the guide slots (A).
▶ Run the GPU cables through the cable clamp (1).
▶ Connect the GPU power cable to the system board connector "PWR 7"
(riser module 2) or "PWR 8" (riser module 1).
▶ Connect the GPU signal cable to the system board.
▶ Install the crossbar, see
▶ Install the air duct, see
▶ Install the corresponding riser module, see
page 74.
Concluding steps
▶
"Reassembling" on page
▶
"Connecting the power cord" on page
▶
"Switching on the server" on page
▶ If applicable,
"Installing the front cover with lock" on page
RX2540 M7
Expansion cards and backup units
"Installing the crossbar" on page
"Installing the air duct" on page
59.
65.
71.
Upgrade and Maintenance Manual
A
84.
79.
"Installing a riser module" on
71.
289