Fujitsu PRIMERGY RX2540 M7 Upgrade And Maintenance Manual page 184

Hard disk drive (HDD) / solid state disk (SSD)
Some SSDs / PCIe SSDs have a write life (limited life component). Ask
the customer to check the write status before replacing the spare part. If
the product has reached the end of its life, ask the customer to purchase
it again.
For Japan, refer to the following:
https://jp.fujitsu.com/platform/server/primergy/support/parts/#parts2
Preliminary steps
▶ If applicable,
"Removing the front cover with lock" on page
▶
"Locating the defective server" on page
▶
"Locating the defective component" on page
Removing the defective 2.5-inch HDD/SSD module
▶ Remove the HDD/SSD module, see
module" on page
▶ If the new HDD/SSD module does not have an installation frame, replace
the installation frame,
on page 138.
Installing the new 2.5-inch HDD module
▶ Install the HDD/SSD module, see
on page 179.
Concluding steps
▶ If applicable,
"Installing the front cover with lock" on page
▶ If the HDD/SSD is configured using a RAID controller with a RAID level
higher than "0", the rebuild will start automatically, see
array rebuild" on page
▶ For a spare disk, verify that it is set to Hotspare in iRMC S6 web interface.
184
181.
"Handling HDDs or SSDs without installation frame"
"Installing a 2.5-inch HDD/SSD module"
108.
Upgrade and Maintenance Manual
47.
48.
"Removing a 2.5-inch HDD/SSD
49.
71.
"Performing a RAID
RX2540 M7