Installer Settings - Daikin Altherma 3 WS EWSAH06UD 9W Series Installer's Reference Manual

11.5.9 Installer settings

Configuration wizard
Domestic hot water
EWSAH/X06UD
Daikin Altherma 3 WS
4P675765-1 – 2022.04
#
[8.A]
Possible read-out information
In menu...
[8.1] Energy data
[8.2] Malfunction history
[8.3] Dealer information
[8.4] Sensors
[8.5] Actuators
[8.6] Operation modes
[8.7] About
[8.8] Connection status
After first power ON of the system, the user interface will guide you using the
configuration wizard. This way you can set the most important initial settings. This
way the unit will be able to run properly. Afterwards, more detailed settings can be
done via the menu structure if required.
To restart the configuration wizard, go to Installer
Configuration wizard [9.1].
Domestic hot water
The following setting determines if the system can prepare domestic hot water or
not, and which tank is used. This setting is read only.
# Code
(a)
[9.2.1] [E‑05]
(a)
[E‑06]
(a)
[E‑07]
(a)
Use the menu structure instead of the overview settings. Menu structure setting [9.2.1]
replaces the following 3 overview settings:
• [E-05]: Can the system prepare domestic hot water?
• [E-06]: Is a domestic hot water tank installed in the system?
• [E-07]: What kind of domestic hot water tank is installed?
Code
N/A
Produced energy, consumed electricity,
and consumed gas
Malfunction history
Contact/helpdesk number
Room, tank or domestic hot water,
outside, and leaving water temperature
(if applicable)
Status/mode of each actuator
Example: Domestic hot water pump
ON/OFF
Current operation mode
Example: Defrost/oil return mode
Version information about the system
Information about the connection
status of the unit, the room thermostat
and the LAN adapter.
▪ No DHW (domestic hot water)
▪ Integrated
The backup heater will also be used for
domestic hot water heating.
11 Configuration
|
Description
Reset the MMI EEPROM
to factory default
You can read out...
settings >
Description
Installer reference guide
193