Setting Up The Domestic Hot Water Tank; System Layout - Integrated Dhw Tank; Selecting The Volume And Desired Temperature For The Dhw Tank - Daikin Altherma 3 WS EWSAH06UD 9W Series Installer's Reference Manual

6.4 Setting up the domestic hot water tank

6.4.1 System layout – Integrated DHW tank

6.4.2 Selecting the volume and desired temperature for the DHW tank

EWSAH/X06UD
Daikin Altherma 3 WS
4P675765-1 – 2022.04
A Auxiliary contact (normally closed)
H Heating demand room thermostat (optional)
K1A Auxiliary relay for activation of indoor unit (field supply)
K2A Auxiliary relay for activation of boiler (field supply)
Indoor Indoor unit
Auto Automatic
Boiler Boiler
NOTICE
▪
Make sure the auxiliary contact has enough differential or time delay to prevent
frequent changeover between indoor unit and auxiliary boiler.
▪
If the auxiliary contact is an outdoor temperature thermostat, install the
thermostat in the shadow so that it is NOT influenced or turned ON/OFF by direct
sunlight.
▪
Frequent changeover may cause corrosion of the auxiliary boiler. Contact the
manufacturer of the auxiliary boiler for more information.
b
A Domestic hot water
a Cold water IN
b Hot water OUT
c Remote outdoor sensor
People experience water as hot when its temperature is 40°C. Therefore, the DHW
consumption is always expressed as equivalent hot water volume at 40°C.
However, you can set the DHW tank temperature at a higher temperature
(example: 53°C), which is then mixed with cold water (example: 15°C).
Selecting the desired temperature for the DHW tank consists of:
1 Determining the DHW consumption (equivalent hot water volume at 40°C).
2 Determining the desired temperature for the DHW tank.
Determining the DHW consumption
Answer the following questions and calculate the DHW consumption (equivalent
hot water volume at 40°C) using typical water volumes:
6
|
a
A
c
Application guidelines
Installer reference guide
45