Yamaha FJR13AG Service Manual page 768

SELF-DIAGNOSTIC FUNCTION AND DIAGNOSTIC CODE TABLE
EAS31059
DIAGNOSTIC CODE TABLE
TIP
Observe the following precautions when executing the diagnostic mode. (Code No. 84)
• Make sure that the battery has been sufficiently charged.
• Place the vehicle on the centerstand.
• After operating the electronically adjustable suspension, wait 5 minutes or more before operating it
again. (If the electronically adjustable suspension is operated repeatedly, fault code No. C1004 may
be indicated due to the operation of the circuit breaker in the rear shock absorber assembly DC mo-
tor.)
• Do not disconnect the battery terminals while the rear shock absorber assembly DC motor is operat-
ing.
Diagnostic
code No.
09 Monitor voltage
84 Preload home position ad-
justment
Item
Displays the monitor voltage.
Approximately 12.0
The "check" indicator on the
Yamaha diagnostic tool
screen comes on when the
preload home position ad-
justment starts.
When completed successful-
ly
The "check" indicator on the
Yamaha diagnostic tool
screen goes off.
When not completed suc-
cessfully
The "check" indicator on the
Yamaha diagnostic tool
screen flashes. Remove the
rear shock absorber assem-
bly DC motor and adjust it by
hand.
After adjusting the DC motor,
perform the procedure for di-
agnostic code No. 84 again.
If the "check" indicator on the
Yamaha diagnostic tool
screen flashes again, re-
place the rear shock absorb-
er assembly.
Refer to "ADJUSTING THE
REAR SHOCK ABSORBER
ASSEMBLY DC MOTOR" on
page 4-130.
9-23
(SCU) (FJR13ESG)
Tool display
Compare the actually mea-
sured battery voltage with
the tool display value. (If the
actually measured battery
voltage is low, recharge the
battery.)
Procedure
—