Yamaha FJR13AG Service Manual page 273

• Before assembling the front fork leg, make
sure all of the components are clean.
1. Install:
• Inner tube bushing
New
• Damper rod assembly
ECA14210
NOTICE
Allow the damper rod assembly to slide
slowly down the inner tube until it protrudes
from the bottom of the inner tube. Be careful
not to damage the inner tube.
2. Lubricate:
• Inner tube's outer surface
Recommended oil
Suspension oil M1 or equivalent
3. Tighten:
• Damper rod assembly bolt
Damper rod assembly bolt
23 Nm (2.3 m·kgf, 17 ft·lbf)
LOCTITE®
TIP
While holding the damper rod assembly with the
damper rod holder "1", tighten the damper rod
assembly bolt.
Damper rod holder (ø32.5)
90890-01513
1
4. Install:
• Outer tube bushing 2 (D = 51 mm (2.01 in), l
= 15 mm (0.59 in)) "1"
(with the slide metal installer "2" and fork seal
driver "3")
New
4-100
FRONT FORK (FJR13AG)
Slide metal installer
90890-01508
Slide metal installer
YM-01508
Fork seal driver
90890-01502
Fork seal driver (48)
YM-A0948
3
New 1
5. Install:
• Outer tube bushing 1 (D = 52 mm (2.05 in), l
= 15 mm (0.59 in)) "1"
• Washer "2"
(with the slide metal installer "3" and fork seal
driver (weight) "4")
Slide metal installer
90890-01508
Slide metal installer
YM-01508
Fork seal driver
90890-01502
Fork seal driver (48)
YM-A0948
4
3
2
New 1
6. Install:
• Oil seal "1"
New
• Suitable washer "2" (ex: 4SV-23115-00)
(with the slide metal installer "3" and fork seal
driver (weight) "4")
2
New