Yamaha FJR13AG Service Manual page 575

Fault code No.
Item
5 Defective cylinder-#4 ignition
coil.
6 Malfunction in ECU.
7 Delete the fault code and check
that the engine trouble warning
light goes off.
Fault code No. P0500
Fault code No.
Item
Fail-safe system
Diagnostic code No.
Tool display
Procedure
Probable cause of malfunc-
Item
tion and check
P0354
Cylinder-#4 ignition coil: open or short circuit detected in the prima-
ry lead of the cylinder-#4 ignition coil.
Measure the primary coil resis-
tance of the cylinder-#4 ignition
coil.
Replace if out of specification.
Refer to "CHECKING THE IG-
NITION COILS" on page 8-257.
Execute the diagnostic mode.
(Code No. 33)
No spark → Replace the ECU.
Refer to "REPLACING THE
ECU (engine control unit)" on
page 8-250.
Confirm that the fault code has
a condition of "Recovered" us-
ing the Yamaha diagnostic tool,
and then delete the fault code.
P0500
Rear wheel sensor: no normal signals are received from the
A
rear wheel sensor.
B Neutral switch: open or short circuit is detected.
C Clutch switch: open or short circuit is detected.
Able to start engine
Able to drive vehicle
07
Rear wheel speed pulse
0–999
Check that the number increases when the rear wheel is rotated. The
number is cumulative and does not reset each time the wheel is stopped.
Maintenance job
8-98
FUEL INJECTION SYSTEM
Start the engine and let it idle for
approximately 5 seconds.
Check the condition of the fault
code using the malfunction
mode of the Yamaha diagnostic
tool.
Condition is "Recovered" → Go
to item 7 and finish the service.
Condition is "Detected" → Go to
item 6.
Service is finished.
Confirmation of service com-
pletion