Yamaha FJR13AG Service Manual page 285

Level (left)
123 mm (4.8 in)
Level (right)
123 mm (4.8 in)
a
14.Install:
• Locknut "1"
• Fork spring
• Spacer
• Cap bolt (with front fork stepping motor)
ECA20270
NOTICE
Do not drop the cap bolt (with front fork step-
ping motor) or subject it to shocks.
▼ ▼▼▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼
a. Remove the rod puller and rod puller attach-
ment.
b. Install the locknut.
TIP
Install the locknut with its tapered side "a" facing
in the direction shown in the illustration.
2
2. Outer tube
c. Install the fork spring and spacer.
TIP
Install the spring with the smaller pitch "a" facing
up "A".
▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼▼▼
1
a
4-112
FRONT FORK (FJR13ESG)
d. Reinstall the rod puller and rod puller attach-
ment.
e. Press down in the spacer with the fork spring
compressor "1".
f. Pull up the rod puller and install the rod holder
"2" between the locknut "3" and the spacer
"4".
TIP
Use the side of the rod holder that is marked "B".
Fork spring compressor
90890-01441
Fork spring compressor
YM-01441
Rod holder
90890-01434
Damper rod holder double ended
YM-01434
3
1
g. Remove the rod puller and the rod puller at-
tachment.
h. Install the cap bolt (with front fork stepping
motor), and then finger tighten it.
TIP
Tighten the cap bolt (with front fork stepping mo-
tor) until it contacts the end of the damper rod
assembly.
EWA17630
WARNING
Always use a new cap bolt (with front fork
stepping motor) O-ring.
A
a
2
4