Yamaha FJR13AG Service Manual page 631

Fault code No.
Item
B-5 Check the fuse. (main fuse, ig-
nition fuse, cruise control sys-
tem fuse)
B-6 Wire harness continuity.
B-7 Defective cruise control setting
switch.
B-8 Malfunction in ECU.
B-9 Delete the fault code and check
that the engine trouble warning
light goes off.
P0564
Cruise control setting switch "RES+": open or short circuit is de-
A
tected.
Cruise control setting switch "SET–": open or short circuit is de-
B
tected.
Abnormality → Replace the
fuse. (main fuse, ignition fuse,
cruise control system fuse)
Open or short circuit → Replace
the wire harness.
Between battery and main
switch coupler.
red–red
Between main switch coupler
and left handlebar switch cou-
pler.
brown/blue–brown/blue
Between left handlebar switch
coupler and ECU coupler.
green/blue–green/blue
Replace the left handlebar
switch.
Replace the ECU.
Refer to "REPLACING THE
ECU (engine control unit)" on
page 8-250.
Confirm that the fault code has
a condition of "Recovered" us-
ing the Yamaha diagnostic tool,
and then delete the fault code.
8-154
CRUISE CONTROL SYSTEM
Turn the main switch to "ON".
Push and "SET–" side of the
cruise control setting switch,
and then check the condition of
the fault code using the mal-
function mode of the Yamaha
diagnostic tool.
Condition is "Recovered" → Go
to item B-9 and finish the ser-
vice.
Condition is "Detected" → Go to
item B-6.
Turn the main switch to "ON".
Push and "SET–" side of the
cruise control setting switch,
and then check the condition of
the fault code using the mal-
function mode of the Yamaha
diagnostic tool.
Condition is "Recovered" → Go
to item B-9 and finish the ser-
vice.
Condition is "Detected" → Go to
item B-7.
Turn the main switch to "ON".
Push the "RES+" side and
"SET–" side of the cruise con-
trol setting switch, and then
check the condition of the fault
code using the malfunction
mode of the Yamaha diagnostic
tool.
Condition is "Recovered" → Go
to item B-9 and finish the ser-
vice.
Condition is "Detected" → Go to
item B-8.