Yamaha FJR13AG Service Manual page 644

EAS30518
TROUBLESHOOTING
The windshield fails to move.
TIP
• Before troubleshooting, remove the following part(s):
1. Front cowling assembly
2. Fuel tank
3. T–bar
1. Check that there are no rocks or
other foreign material in the wind-
shield drive unit side rails.
OK ↓
2. Check that there is no foreign mate-
rial between the cable and the pul-
ley.
OK ↓
3. Check the fuses.
(Main, ignition, signaling system,
and windshield motor)
Refer to "CHECKING THE FUS-
ES" on page 8-250.
OK ↓
4. Check the battery.
Refer to "CHECKING AND
CHARGING THE BATTERY" on
page 8-251.
OK ↓
5. Check the main switch.
Refer to "CHECKING THE
SWITCHES" on page 8-247.
OK ↓
6. Check the menu switch.
Refer to "CHECKING THE
SWITCHES" on page 8-247.
OK ↓
7. Check the select switch.
Refer to "CHECKING THE
SWITCHES" on page 8-247.
OK ↓
8. Check the windshield drive unit re-
lay (up).
Refer to "CHECKING THE RE-
LAYS" on page 8-254.
OK ↓
WINDSHIELD DRIVE SYSTEM
NG →
Remove the foreign material.
NG →
Remove the foreign material.
NG →
Replace the fuse(s).
NG →
• Clean the battery terminals.
• Recharge or replace the battery.
NG →
Replace the main switch/immobilizer unit.
NG →
• The menu switch is faulty.
• Replace the left handlebar switch.
NG →
• The select switch is faulty.
• Replace the left handlebar switch.
NG →
Replace the windshield drive unit relay
(up).
8-167