Yamaha FJR13AG Service Manual page 113

1. Starter motor lead
2. ECU (engine control unit) coupler
3. Brake hose (front brake master cylinder to brake
pipe/lower joint assembly)
4. Handlebar switch lead (right)
5. Throttle cable (accelerator cable)
6. Throttle cable (decelerator cable)
7. Headlight relay
8. Radiator fan motor relay
9. Starter relay coupler
10. Front turn signal/position light coupler (right)
11. ABS test coupler lead
12. Radiator fan motor coupler (right)
13. Negative battery lead
14. O sensor lead
2
15. Water pump breather hose
16. Crankshaft position sensor lead
17. Blind plug
18. O sensor coupler
2
19. Fuse box 4
20. Fuse box 2
21. Fuse box 1
22. Fuse box 3
23. Fuses (brake light and cruise control system)
24. ECU (engine control unit) leads
25. Wire harness
A. Blue tape
B. To electrical components board
C. Cover the positive battery lead terminal and starter
motor lead terminal with the covers.
D. Pass the starter motor lead through the guide on
the electrical components tray.
E. Insert the projection on the wire harness holder
completely into the hole in the electrical
components tray.
F. Fasten the right radiator fan motor lead with the
holder on the air guide.
G. Route the right radiator fan motor lead between the
leads (starter motor lead, negative battery lead,
and O sensor lead) and the base of the holder
2
that is fastening the leads.
H. Fasten the negative battery lead, starter motor
lead, O sensor lead, and water pump breather
2
hose with a plastic locking tie, making sure to
install the tie around the end of the hose
protective sleeve, and then cut off the excess end
of the tie. Do not kink the water pump breather
hose and do not face the end of the plastic locking
tie downward.
I. Fasten the O sensor lead and crankshaft position
2
sensor lead with the holder.
J. Route the O sensor lead to the rear of the blind
2
plug.
K. The plastic locking tie on the O
should be positioned to the front of the bracket.
L. Install the fuse boxes securely onto the brackets
" "
until a distinct click is heard.
M. Install the fuse holder for the brake light fuse and
cruise control system fuse completely onto the tab
on the electrical components tray.
CABLE ROUTING (FJR13ESG)
"
s
sensor lead
2
2-60
N. Fasten the leads with the plastic band so that they
are positioned in a straight line as shown in the
illustration. Face the end of the plastic band
forward. Do not cut off the excess end of the plastic
band.
O. Outward
P. Route the O sensor lead to the outside of the
2
other leads and the hose.