Yamaha FJR13AG Service Manual page 40

ECA16620
NOTICE
Handle electrical components with special
care, and do not subject them to strong
shocks.
ECA16630
NOTICE
Electrical components are very sensitive to
and can be damaged by static electricity.
Therefore, never touch the terminals and be
sure to keep the contacts clean.
TIP
When resetting the ECU by turning the main
switch to "OFF", be sure to wait approximately 5
seconds before turning the main switch back to
"ON".
BASIC SERVICE INFORMATION
ECA23620
NOTICE
• Do not perform angle adjustment of the IMU
and rear fender by pinching the washer and
related parts.
• When installing the IMU, apply a thin coat of
silicone grease onto the washer where con-
tacting the IMU grommet.
• When installing the IMU, use only a genuine
bolt and washer, and tighten the bolt to the
specified torque.
• Pay attention not to expose the IMU to
strong shocks, such as striking or drop-
ping it.
• Do not place any foreign objects in and
around the IMU.
• Do not obstruct breather opening "a" of the
IMU.
• Do not clean the breather opening and do
not blow it with compressed air.
• When replacing the collar or grommet, re-
place all four collars and grommets.
1-31
a