Changing The Coolant - Yamaha FJR13AG Service Manual

10
9
5
3. Install:
• Exhaust pipe assembly
Refer to "ENGINE REMOVAL" on page 5-3.
• Side cowlings
Refer to "GENERAL CHASSIS (2)" on page
4-5.
EAS30068

CHANGING THE COOLANT

1. Remove:
• Side cowlings
Refer to "GENERAL CHASSIS (2)" on page
4-5.
2. Remove:
• Radiator cap "1"
EWA13030
WARNING
A hot radiator is under pressure. Therefore,
do not remove the radiator cap when the en-
gine is hot. Scalding hot fluid and steam may
be blown out, which could cause serious in-
jury. When the engine has cooled, open the
radiator cap as follows:
7
8
2
6
1
3-29
PERIODIC MAINTENANCE
Place a thick rag or a towel over the radiator
cap and slowly turn the radiator cap counter-
clockwise toward the detent to allow any re-
sidual pressure to escape. When the hissing
sound has stopped, press down on the radi-
ator cap and turn it counterclockwise to re-
move.
3. Remove:
• Coolant drain bolt (water pump) "1"
(along with the copper washer)
4. Disconnect:
• Radiator outlet hose "2"
5. Drain:
• Coolant
(from the engine and radiator)
6. Remove:
• Coolant reservoir "1"
• Coolant reservoir cap "2"
7. Drain:
• Coolant
(from the coolant reservoir)
8. Install:
• Coolant reservoir
9. Connect:
• Radiator outlet hose
10.Install:
• Coolant drain bolt (water pump)
(along with the copper washer
Coolant drain bolt (water pump)
10 Nm (1.0 m·kgf, 7.2 ft·lbf)
2
1
)
New