Chassis Tightening Torques - Yamaha FJR13AG Service Manual

EAS30017

CHASSIS TIGHTENING TORQUES

Item
Upper bracket pinch bolt
Lower bracket pinch bolt
Front wheel axle bolt
Front wheel axle pinch bolt
Rear wheel axle nut
Rear wheel axle pinch bolt
Front brake caliper bolt
Front brake caliper bleed screw
Rear brake caliper bolt
Rear brake caliper bleed screw
Final gear oil drain bolt
TIP
Front wheel axle pinch bolt
1. Insert the front wheel axle from the right side and tighten it with the front wheel axle bolt from the left
side to 91 Nm (9.1 m·kgf, 66 ft·lbf).
2. In the order pinch bolt "2" → pinch bolt "1" → pinch bolt "2", tighten each bolt to 21 Nm (2.1 m·kgf,
15 ft·lbf) without performing temporary tightening.
3. Check that the right end of the front axle is flush with the front fork. If necessary, manually push the
front axle or lightly tap it with a soft hammer until its end is flush with the front fork. However, if the
surface of the front axle end is not parallel to the surface of the front fork, align a point on the outer
edge of the axle with the fork, making sure that the axle does not protrude past the fork.
4. In the order pinch bolt "4" → pinch bolt "3" → pinch bolt "4", tighten each bolt to 21 Nm (2.1 m·kgf,
15 ft·lbf) without performing temporary tightening.
Thread
Q'ty
size
M8 2 26 Nm (2.6 m·kgf, 19 ft·lbf)
M8 4 23 Nm (2.3 m·kgf, 17 ft·lbf)
M14 1 91 Nm (9.1 m·kgf, 66 ft·lbf)
M8 4
M18 1 125 Nm (12.5 m·kgf, 90 ft·lbf)
M8 1 23 Nm (2.3 m·kgf, 17 ft·lbf)
M10 4 40 Nm (4.0 m·kgf, 29 ft·lbf)
M8 3 6 Nm (0.6 m·kgf, 4.3 ft·lbf)
M10 2 27 Nm (2.7 m·kgf, 20 ft·lbf)
M7 1 6 Nm (0.6 m·kgf, 4.3 ft·lbf)
M14 1 23 Nm (2.3 m·kgf, 17 ft·lbf)
3 2
4
2-15
TIGHTENING TORQUES
Tightening torque
See TIP.
1
Remarks
S