Yamaha FJR13AG Service Manual page 560

Table of Contents

Advertisement

Fault code No.
Item
5
Throttle position sensor resis-
tance.
6
Defective throttle position sen-
sor.
7
Malfunction in ECU.
8
Delete the fault code and check
that the engine trouble warning
light goes off.
Fault code No. P0132
Fault code No.
Item
Fail-safe system
Diagnostic code No.
Tool display
Procedure
P0122, P0123, P0222, P0223, P2135
[P0122, P0222] Throttle position sensor: ground short circuit detect-
ed.
[P0123, P0223] Throttle position sensor: open or power short circuit
detected.
[P2135] Deviation error
Measure the throttle position
sensor resistance.
black/blue–blue
Refer to "CHECKING THE
THROTTLE POSITION SEN-
SOR" on page 8-263.
Check throttle position sensor
signal 1.
Execute the diagnostic mode.
(Code No. 01)
When the throttle valves are ful-
ly closed:
A value of 12–21 is indicated.
When throttle valves are fully
open:
A value of 97–106 is indicated.
Check throttle position sensor
signal 2.
Execute the diagnostic mode.
(Code No. 13)
When the throttle valves are ful-
ly closed:
A value of 9–23 is indicated.
When the throttle valves are ful-
ly open:
A value of 94–108 is indicated.
An indicated value is out of the
specified range → Replace the
throttle position sensor.
Replace the ECU.
Refer to "REPLACING THE
ECU (engine control unit)" on
page 8-250.
Confirm that the fault code has
a condition of "Recovered" us-
ing the Yamaha diagnostic tool,
and then delete the fault code.
P0132
O
sensor: short circuit detected (power short circuit).
2
Able to start engine
Able to drive vehicle
8-83
FUEL INJECTION SYSTEM
Turn the main switch to "ON",
and then check the condition of
the fault code using the mal-
function mode of the Yamaha di-
agnostic tool.
Condition is "Recovered" → Go
to item 8 and finish the service.
Condition is "Detected" → Go to
item 6.
Turn the main switch to "ON",
and then check the condition of
the fault code using the mal-
function mode of the Yamaha di-
agnostic tool.
Condition is "Recovered" → Go
to item 8 and finish the service.
Condition is "Detected" → Go to
item 7.
Service is finished.

Advertisement

Table of Contents

Troubleshooting

loading

This manual is also suitable for:

Fjr13esg

Table of Contents