Yamaha FJR13AG Service Manual page 30

• The "L/100km" display shows the average
amount of fuel necessary to travel 100 km.
• The "MPG" display shows the average dis-
tance that can be traveled on 1.0 Imp.gal of fu-
el.
To reset the average fuel consumption display,
use the select switch to select the information
display that contains the average fuel consump-
tion display. Push the "RESET" button briefly so
that the average fuel consumption display flash-
es, and then push the "RESET" button again for
2 seconds while the display is flashing.
TIP
After resetting the average fuel consumption dis-
play, "_ _._" will be shown for that display until
the vehicle has traveled 1 km (0.6 mi).
Instantaneous fuel consumption display:
CRNT FUEL
The instantaneous fuel consumption display
modes "km/L", "L/100km" or "MPG" show the
fuel consumption under the current riding condi-
tions.
• The "km/L" display shows the distance that can
be traveled on 1.0 L of fuel.
• The "L/100km" display shows the amount of
fuel necessary to travel 100 km.
• The "MPG" display shows the distance that
can be traveled on 1.0 Imp.gal of fuel.
TIP
If traveling at speeds under 10 km/h (6 mi/h), "_
_._" will be displayed.
km/L
12.3
1-21
Adjusting the windshield position
1. To move the windshield up, push the "
side of the select switch. To move the wind-
shield down, push the "
switch.
Setting mode
MENU
Grip Warmer
Maintenance
Time Trip
Unit
Display
Brightness
Clock
1. Setting mode display
TIP
• The transmission must be in neutral and the
vehicle must be stopped to change settings in
this mode.
• Shifting the transmission into gear and starting
off, or turning the key to "OFF", saves all set-
tings made, then exits the setting mode.
Push and hold the menu switch "MENU" for 2
seconds to enter the setting mode. To exit the
setting mode and return to the normal display,
push and hold the menu switch "MENU" again
for at least 2 seconds.
Display Description
This function allows
you to set the low,
Grip Warm-
middle, and high set-
er
tings to 10 tempera-
ture levels.
This function allows
you to check and re-
set the "OIL" oil
Mainte- change interval (dis-
nance tance traveled), and
the "FREE-1" and
"FREE-2" mainte-
nance intervals.
FEATURES
"
" side of the select
1