Yamaha FJR13AG Service Manual page 161

4. Drain:
• Engine oil
(completely from the crankcase)
5. If the oil filter cartridge is also to be replaced,
perform the following procedure.
▼ ▼▼▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼
a. Remove the oil filter cartridge "1" with the oil
filter wrench "2".
Oil filter wrench
90890-01426
Oil filter wrench
YU-38411
2
1
b. Lubricate the O-ring "3" of a new oil filter car-
tridge with a thin coat of engine oil.
ECA13390
NOTICE
Make sure the O-ring "3" is positioned cor-
rectly in the groove of the oil filter cartridge.
c. Tighten the new oil filter cartridge to specifi-
cation with the oil filter wrench.
1
2
▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼▼▼
3-26
PERIODIC MAINTENANCE
Oil filter cartridge
17 Nm (1.7 m·kgf, 12 ft·lbf)
▲ ▲▲▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲
6. Install:
• Engine oil drain bolt
(along with the gasket
Engine oil drain bolt
43 Nm (4.3 m·kgf, 31 ft·lbf)
7. Fill:
• Crankcase
(with the specified amount of the recom-
mended engine oil)
Engine oil quantity
Quantity (disassembled)
4.90 L (5.18 US qt, 4.31 Imp.qt)
Oil change
3.80 L (4.02 US qt, 3.34 Imp.qt)
With oil filter removal
4.00 L (4.23 US qt, 3.52 Imp.qt)
8. Install:
• Engine oil filler cap
9. Start the engine, warm it up for several min-
utes, and then turn it off.
10.Check:
• Engine
(for engine oil leaks)
11.Check:
• Engine oil level
Refer to "CHECKING THE ENGINE OIL
LEVEL" on page 3-25.
12.Check:
• Engine oil pressure
▼ ▼▼▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼
a. Remove the right side cowling.
Refer to "GENERAL CHASSIS (2)" on page
4-5.
b. Slightly loosen the engine oil check bolt "1".
▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲▲▲
)
New
▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼▼▼