Yamaha FJR13AG Service Manual page 762

SELF-DIAGNOSTIC FUNCTION AND DIAGNOSTIC CODE TABLE
Diagnostic
code No.
60 EEPROM fault code display
• No history
• History exists
Display the EEPROM writ-
ing error for fault code No.
P062F.
If more than one item is de-
fective, the displays alter-
nates every two seconds to
show all the detected num-
bers.
67 ISC (idle speed control)
learning condition display
ISC (idle speed control)
learning data erasure
70 Control number
80 Cruise control setting switch
"RES+"
• Switch is pushed
• Switch is released
81 Cruise control setting switch
"SET–"
• Switch is pushed
• Switch is released
Item
00
• No malfunctions detected
(If the self-diagnosis fault
code P062F is indicated,
the ECU is defective.)
01–04 (CO adjustment val-
ue)
• (If more than one cylinder is
defective, the display alter-
nates every two seconds to
show all the detected cylin-
der numbers.
When all cylinder numbers
are shown, the display re-
peats the same process.)
11 (Data error for ISC (idle
speed control) learning val-
ues)
12 (O
2
ue)
13 (OBD memory value)
00
ISC (idle speed control)
learning data has been
erased.
01
It is not necessary to erase
the ISC (idle speed control)
learning data.
02
It is necessary to erase the
ISC (idle speed control)
learning data.
0–254 [-]
ON
OFF
ON
OFF
9-17
Tool display
—
—
feedback learning val-
To erase the ISC (idle speed
control) learning data, set the
start/engine stop switch from
"
onds.
—
Push and release the
"RES+" side of the cruise
control setting switch.
Push and release the "SET–"
side of the cruise control set-
ting switch.
(ECU)
Procedure
" to " " 3 times in 5 sec-