Yamaha FJR13AG Service Manual page 513

Fault code No.
Item
7 Malfunction in IMU.
8 Malfunction in CLCU.
Fault code No. P0500
Fault code No.
Item
Fail-safe system
Diagnostic code No.
Tool display
Procedure
Probable cause of malfunc-
Item
tion and check
1 Refer to the information for fuel
injection system fault code No.
P0500.
Refer to "TROUBLESHOOT-
ING DETAILS (ECU) (FAULT
CODE)" on page 8-62.
Fault code No. U0100
Fault code No.
Item
Fail-safe system
Diagnostic code No.
Tool display
Procedure
CORNERING LIGHT SYSTEM (FJR13ESG)
C0520
CLCU receives a signal from the IMU indicating that a malfunction
was detected or the CLCU does not receive normal signals from the
IMU.
Replace the IMU.
Replace the headlight assem-
bly.
P0500
Rear wheel sensor: no normal signals are received from the
A
rear wheel sensor.
B Neutral switch: open or short circuit is detected.
C Clutch switch: open or short circuit is detected.
Able to start engine
Able to drive vehicle
07
Rear wheel speed pulse
0–999
Check that the number increases when the rear wheel is rotated. The
number is cumulative and does not reset each time the wheel is stopped.
Maintenance job
—
U0100
Signals cannot be transmitted between the CLCU and the ECU.
Able to start engine
Able to drive vehicle
—
—
—
8-36
Turn the main switch to "ON",
and then check that the corner-
ing lights come on and go off in
the proper sequence.
Lighting sequence is correct →
Service is finished.
Lighting sequence is not correct
→ Go to item 8.
Turn the main switch to "ON",
and then check that the corner-
ing lights come on and go off in
the proper sequence.
Lighting sequence is correct →
Service is finished.
Confirmation of service com-
pletion
Turn the main switch to "ON",
and then check that the corner-
ing lights come on and go off in
the proper sequence.
Lighting sequence is correct →
Service is finished.