Yamaha FJR13AG Service Manual page 524

The turn signal light, turn signal indicator light or both fail to blink.
1. Check the front turn signal/position
light assembly(-ies).
Refer to "CHECKING THE FRONT
TURN SIGNAL/POSITION LIGHT
ASSEMBLY" on page 8-262.
OK ↓
2. Check the turn signal switch.
Refer to "CHECKING THE
SWITCHES" on page 8-247.
OK ↓
3. Check the hazard switch.
Refer to "CHECKING THE
SWITCHES" on page 8-247.
OK ↓
4. Check the entire signaling system
wiring.
Refer to "CIRCUIT DIAGRAM
(FJR13AG)" on page 8-41 or refer
to "CIRCUIT DIAGRAM
(FJR13ESG)" on page 8-43.
OK ↓
Replace the meter assembly or
tail/brake light assembly.
The neutral indicator light fails to come on.
1. Check the gear position switch.
Refer to "CHECKING THE GEAR
POSITION SWITCH" on page
8-264.
OK ↓
2. Check the relay unit (diode).
Refer to "CHECKING THE RELAY
UNIT (DIODE)" on page 8-256.
OK ↓
3. Check the entire signaling system
wiring.
Refer to "CIRCUIT DIAGRAM
(FJR13AG)" on page 8-41 or refer
to "CIRCUIT DIAGRAM
(FJR13ESG)" on page 8-43.
OK ↓
Replace the meter assembly.
SIGNALING SYSTEM
NG →
Replace the front turn signal/position light
assembly(-ies).
NG →
• The turn signal switch is faulty.
• Replace the left handlebar switch.
NG →
• The hazard switch is faulty.
• Replace the right handlebar switch.
NG →
Properly connect or replace the wire har-
ness.
NG →
Replace the gear position switch.
NG →
Replace the relay unit.
NG →
Properly connect or replace the wire har-
ness.
8-47