Yamaha FJR13AG Service Manual page 576

Fault code No.
Item
A-1 Locate the malfunction.
A-2 Connection of rear wheel sen-
sor coupler.
Check the locking condition of
the coupler.
Disconnect the coupler and
check the pins (bent or broken
terminals and locking condition
of the pins).
A-3 Connection of ABS ECU cou-
pler.
Check the locking condition of
the coupler.
Disconnect the coupler and
check the pins (bent or broken
terminals and locking condition
of the pins).
A-4 Connection of ECU coupler.
Check the locking condition of
the coupler.
Disconnect the coupler and
check the pins (bent or broken
terminals and locking condition
of the pins).
P0500
Rear wheel sensor: no normal signals are received from the
A
rear wheel sensor.
B Neutral switch: open or short circuit is detected.
C Clutch switch: open or short circuit is detected.
Execute the diagnostic mode.
(Code No. 07)
Rotate the rear wheel by hand
and check that the indicated val-
ue increases.
Execute the diagnostic mode.
(Code No. 21)
When the transmission is in
neutral: "ON"
When the transmission is in
gear with the clutch lever re-
leased: "OFF"
When the transmission is in
gear with the clutch lever
squeezed and the sidestand re-
tracted: "ON"
Improperly connected → Con-
nect the coupler securely or re-
place the wire harness.
Improperly connected → Con-
nect the coupler securely or re-
place the wire harness.
Improperly connected → Con-
nect the coupler securely or re-
place the wire harness.
8-99
FUEL INJECTION SYSTEM
Value does not increase → Go
to item A-2.
Incorrect indication → Go to
item B-2 for the neutral switch.
Incorrect indication → Go to
item C-2 for the clutch switch.
Execute the diagnostic mode.
(Code No. 07)
Rotate the rear wheel by hand
and check that the indicated val-
ue increases.
Value increases → Go to item
A-8.
Value does not increase → Go
to item A-3.
Execute the diagnostic mode.
(Code No. 07)
Rotate the rear wheel by hand
and check that the indicated val-
ue increases.
Value increases → Go to item
A-8.
Value does not increase → Go
to item A-4.
Execute the diagnostic mode.
(Code No. 07)
Rotate the rear wheel by hand
and check that the indicated val-
ue increases.
Value increases → Go to item
A-8.
Value does not increase → Go
to item A-5.