Yamaha FJR13AG Service Manual page 121

1. Wire harness
2. Option parts (air bag coupler)
3. Tail/brake light assembly coupler
4. IMU sub-wire harness coupler
5. Tail/brake light assembly
6. Rear turn signal light lead
7. License plate light lead
8. Seat lock cable
9. Rear wheel sensor lead
10. Rear brake light switch lead
11. Hydraulic unit assembly
12. Rear shock absorber assembly stepping motor
lead
13. Rear shock absorber assembly DC motor lead
14. Brake light relay
15. Brake switch relay
16. ABS ECU coupler
17. Tail/brake light
18. Rear turn signal light
19. Rear shock absorber assembly stepping motor
lead coupler
A. Position the front and rear joint couplers on top of
the wire harness, and position the middle joint
coupler to the left of the harness.
B. Pass the license plate light lead through the hole in
the rear fender.
C. Route the wire harness to the inside of the seat
lock cable.
D. Route the rear shock absorber assembly stepping
motor lead and DC motor lead between the
couplers (shift actuator motor coupler and shift
actuator sensor coupler) and the rear fender, and
then route the leads downward through the hole in
the rear fender.
E. Insert the projection on the wire harness holder
into the hole in the rear fender.
F. Secure the plastic band by inserting the projection
on the band into the hole in the rear fender, and
then fasten the wire harness at the positioning tape
with the band.
G. Securely connect the ABS ECU coupler.
H. Route the tail/brake light assembly lead as shown
in the illustration.
I. Route the tail/brake light assembly lead between
the tail/brake light assembly and its bracket.
J. Route the rear shock absorber assembly stepping
motor lead through the electrical pump cover,
making sure not to pinch the lead.
K. Insert the projection on the wire harness holder
into the hole in the frame cross member.
L. Make sure that the rear shock absorber assembly
DC motor lead is not routed to the front of the
coupler.
CABLE ROUTING (FJR13ESG)
2-68