Setting Port Vid - ZyXEL Communications XS1930-12HP User Manual

In the Static VLAN screen, select ACTIVE,
2
enter a descriptive name in the Name
field, enter 2 in the VLAN Group ID field for
the VLAN2 network, and use the default
VLAN type, Normal, in the VLAN Type field.
Note: The VLAN Group ID field in this screen and the VID field in the IP Setup screen refer to the
same VLAN ID.
Since the VLAN2 network is connected to port 1 on the Switch, select Fixed to configure port 1 to be a
3
permanent member of the VLAN only.
To ensure that VLAN-unaware devices (such as computers and hubs) can receive frames properly, clear
4
the TX Tagging check box to set the Switch to remove VLAN tags before sending.
Click Add to save the settings to the run-time memory. Settings in the run-time memory are lost when the
5
Switch's power is turned off.

5.1.2 Setting Port VID

Use PVID to add a tag to incoming untagged frames received on that port so that the frames are
forwarded to the VLAN group that the tag defines.
In the example network, configure 2 as the port VID on port 1 so that any untagged frames received on
that port get sent to VLAN 2.
Chapter 5 Initial Setup Example
XS1930 Series User's Guide
65