Mld Snooping-Proxy Filtering - ZyXEL Communications MES3500-24S User Manual

Table 91 Advanced Application > Multicast > IPv6 Multicast > MLD Snooping-proxy > Port Role Setting
LABEL
Leave Mode
Leave Timeout
Fast Leave Timeout
Apply
Cancel

25.4.4 MLD Snooping-proxy Filtering

Use this screen to configure the Switch's MLD filtering settings. Click the Filtering link in the Advanced
Application > Multicast > IPv6 Multicast > MLD Snooping-proxy screen to display the screen as shown.
Chapter 25 Multicast
DESCRIPTION
Select the leave mode for the specified downstream port(s) in this VLAN.
This specifies whether the Switch removes an MLD snooping membership entry (learned
on a downstream port) immediately (Immediate) or wait for an MLD report before the
leave timeout (Normal) or fast leave timeout (Fast) when an MLD leave message is
received on this port from a host.
Enter the MLD snooping normal leave timeout (in milliseconds) the Switch uses to update
the forwarding table for the specified downstream port(s).
This defines how many seconds the Switch waits for an MLD report before removing an
MLD snooping membership entry (learned on a downstream port) when an MLD Done
message is received on this port from a host.
Enter the fast leave timeout (in milliseconds) for the specified downstream port(s).
This defines how many seconds the Switch waits for an MLD report before removing an
MLD snooping membership entry (learned on a downstream port) when an MLD Done
message is received on this port from a host.
Click Apply to save your changes to the Switch's run-time memory. The Switch loses
these changes if it is turned off or loses power, so use the Save link on the top navigation
panel to save your changes to the non-volatile memory when you are done configuring.
Click Cancel to reset the fields to your previous configuration.
MES3500-24S/MGS3520 Series User's Guide
212