Table of Contents
Advertisement
QMultiFlex-400™ Installation and Operating Handbook
The Click to apply routes button must be selected to apply the static routes before
navigating away from the web page.
The Show Routes button can be used to display the underlying operating system 'route
add' commands applied to the TCP/IP stack, thereby providing confirmation of the active
static routes.
6.2.24
Edit->Paired Carrier Screen
If Paired Carrier is an enabled feature, you will see the Paired Carrier tab where the hub
cancellation settings can be configured.
Figure 6-46 Edit->Paired Carrier Screen
6.2.24.1 Paired Carrier Enable
This is an On/Off control to enable the cancellation of the outbound carrier, so that the
receive carriers can be obtained. Typically, this control will not be enabled until Paired
Carrier has been correctly configured.
6-62
Advertisement
Table of Contents
