Table of Contents
Advertisement
QMultiFlex-400™ Installation and Operating Handbook
6.2.22.25
Enable VLAN filtering / VLAN ID
This control is used exclusively for mesh mode operation. See separate document: AN_057
P2MP Mesh Network Routing Mode Configuration Notes available from technical support.
6.2.22.26
Remote to Remote Comms
This is an On/Off control that controls whether traffic received from a remote modem is
retransmitted over satellite to the other remote modems. By supporting double satellite
hops, this enables remote-to-remote communications. Care should be taken with this mode
because recirculating packets in this way could confuse intelligent ethernet switches in the
system by giving the appearance that the location of the remote modem has changed,
causing switches to reconfigure themselves incorrectly.
6.2.23
Edit->IP->Static Routes Screen
The Edit->IP->Static Routes screen, shown in Figure 6-45, allows up to 16 static routes to
be added.
Each route consists of a destination IP address, subnet mask and a gateway address.
The Add button must be selected in order to enable each route.
The Del button is used to delete individual routes.
Figure 6-45 Edit->IP->Static Routes Screen
6-61
Advertisement
Table of Contents
