Table of Contents
Advertisement
8.8.3.1 Hub Tx Carrier Settings
Figure 8-35 QMultiFlex-400™ Edit->Service->General Settings
QMultiFlex-400™ Installation and Operating Handbook
8-49
System
Overall topology is Star.
Tx Service & MODCOD
These values were determined in the test
plan. 32APSK was chosen so that ACM
would have more range. It is good practice
to check the frame size matches that set
on the remote modem.
Tx Carrier
IF Bands are 50 to 90MHz and 100 to 180
MHz. Set desired roll-off factor.
RX IF band is set here.
These labels are for identification of the
link and can be set to the destination name
or service type. In this example VLAN IDs
are used. The demods can be disabled /
enabled here.
Advertisement
Table of Contents
