Table of Contents
Advertisement
QMultiFlex-400™ Installation and Operating Handbook
Figure 6-21 Edit->Service->General->Tx QoS Screen for
The IEEE 802.1p priority classes (part of the IEEE 802.1Q header) are represented as 0 to
7 in the left-hand column. For each QoS rule, the bandwidth to be made available is defined
by the CIR and BIR values. A default rule is available to explicitly reserve bandwidth for
packets that do not have an IEEE 802.1p priority marking.
6.2.7
Edit->Service->Demods Screen
The Edit->Service->Demods screen is shown in Figure 6-22.
Effect of Demodulator Configuration Changes
•
In order not to interfere with other active demodulators, a
demodulator needs to be disabled before its configuration can be
changed.
•
The receiver covers a 72MHz frequency span and this will be
automatically centred based on the lowest and highest centre
frequencies of the active demodulators. Configuration changes
made to a demodulator will not affect the operation of the active
demodulators unless the receiver centre frequency needs to be
changed, in which case all demodulators will be briefly interrupted.
Primary QoS: IEEE 802.1p (Single Stream)
6-28
Advertisement
Table of Contents
