Table of Contents
Advertisement
QMultiFlex-400™ Installation and Operating Handbook
6.2.6.6 Screens for Primary QoS: IP Address
When the primary QoS method is set to IP address then the screen shown in Figure 6-16
will be displayed when using a single stream (i.e. a single MODCOD is being used for the
shared outbound).
Figure 6-16 Edit->Service->General->Tx QoS Screen for
Primary QoS: IP Address (Single Stream)
Any combination of source and destination addresses and ports can be used to define the
packets that will be governed by each QoS rule. For each QoS rule, the bandwidth to be
made available is defined by the CIR and BIR values.
For multiple streams, with the primary QoS method set to IP address, the screen shown in
Figure 6-17 will be displayed. The Tabs 'MODCODs' and 'Primary QoS 1 to 8' will be
displayed. The MODCOD tab allows the MODCOD associated with each stream in the
shared outbound carrier to be configured (See Figure 6-18). Selecting the Primary QoS
tab then allows the IP address rules for each stream to be set up as shown in Figure 6-19.
6-24
Advertisement
Table of Contents
