Table of Contents
Advertisement
8.8.3
QMultiFlex-400™ Hub Configuration
The starting point for modem configuration should be from factory defaults. If the modem
already has a configuration, then it needs to be cleared. Once the modem is booted,
defaults can be recalled on the front panel.
Press Main Key to return to the main menu:
The menu options are selectable by moving the cursor using the arrow buttons on the front
panel. Then pressing enter on the option you would like. The faster method is just to press the
number associated with that option e.g. above the Edit option can be selected by simply
pressing the '2' key.
The QMultiFlex-400™ address will be changed from the default to: 10.0.70.10 / 16.
M&C IP Address:
[010.000.070.001]
[010.000.070.010]
Press enter again to move to the next screen. Edit the
subnet mask. Press enter again to move it to the top
line position.
It will now be possible to connect to the modem using the address 10.0.70.10
In this example the PC is set to 10.0.70.100 / 16
Connect a LAN cable to the M&C port of the modem. Connection LEDs should illuminate on
the IP port. Pinging 10.0.70.10 should show replies.
In a web browser type in the modem M&C address into the address bar.
Default credentials are:
Username: admin
Password: paradise
QMultiFlex-400™ Installation and Operating Handbook
Move cursor to the end of the line and enter the '10' in
the last two digits. Then press enter. The number will
move to the top line to show the current value.
3:View
M&C IP subnet mask:
[255.255.000.000]
[255.255.000.000]
8-47
[QMultiFlex-400]
1:Status 2:Edit
4:Test
Advertisement
Table of Contents
