8.8.3.4 Hub QoS Settings
We are going to apply some QoS rules based on VLAN numbers. The VLANs will be set to
the same priority, but the Burst Information Rate (BIR) will be set to 99% to allow any VLAN
to use any available throughput up to 99%. At least 1% will be reserved for the M&C VLAN
– which is set to the highest priority on the default traffic. This will ensure the M&C traffic
does not lose connection. The committed information rate (CIR) values must total 100% -
so the following will be used:
VLAN10: 33% CIR | 99% BIR | Priority 1
VLAN20: 33% CIR | 99% BIR | Priority 1
VLAN30: 33% CIR | 99% BIR | Priority 1
Default: 1% CIR | 5% BIR | Priority 0
Figure 8-38 QMultiFlex-400™ Edit->General->Tx QoS Settings
VLAN trunking mode is selected and the QMultiFlex-400™ will expect an IEEE 802.1q trunk
to be connected to the IP traffic port.
QMultiFlex-400™ Installation and Operating Handbook
8-52