Table of Contents
Advertisement
QMultiFlex-400™ Installation and Operating Handbook
6.2.5.3 Screens for Primary QoS: VLAN ID
The Edit->Service->General->Tx QoS screen reconfigures itself depending on the settings
for the primary QoS method.
When the primary QoS method is set to VLAN ID then the screen shown in Figure 6-13 will
be displayed in the case where a single stream (i.e. single MODCOD) is being used for the
shared outbound carrier.
Figure 6-13 Edit->Service->General->Tx QoS Screen
Primary QoS Method VLAN ID (Single Stream)
Using VLANs with Cascaded QMultiFlex-400™ Units
Multiple QMultiFlex-400™ units can be cascaded together in order to
transmit a single outbound carrier to an arbitrarily large number of
remote modems.
The number of supported VLAN ID rules is determined by the number
of demodulators that are available and whether multiple QMultiFlex-
400™ units have been cascaded together
When cascading, the number of VLAN ID QoS rules that are supported
will automatically expand up to 64. When cascading more than four
QMultiFlex-400™ units together, please consult Technical Support for
further set up details.
6-20
Advertisement
Table of Contents
