Table of Contents
Advertisement
QMultiFlex-400™ Installation and Operating Handbook
Even though the QMultiFlex-400™ hub is set to 'Trunk Mode' it is actually operating
1.
like bridge mode due to the IP traffic card. The Q-Flex400™ remote should be set to
bridge mode as it is here.
Bridge M&C default is 'Checked' (On) and needs to be unchecked (Off).
2.
3.
ACM is off initially. This is so some preliminary testing can be completed first.
4.
The M&C VLAN default is 0. I changed it to 1. A reboot of the QMultiFlex-400™ is
required to use the new M&C VLAN address.
8.8.4.3 Remote 1 Advanced IP Settings
Figure 8-41 QFlex-400™ Remote 1 Edit->IP->Advanced Settings
1.
Just like the hub side, the satellite buffer is set to 8 packets.
2.
It is recommended for each remote site to be on a separate VLAN. The VLAN filtering
control is where a single VLAN ID can be entered, which is the wanted traffic. All other
traffic is dropped. From a security point of view this is typically desirable.
3.
Point-to-multipoint operation: This is an essential setting for point to multipoint systems
and puts the remote into a different mode of operation. The stream identifier is for ACM
and will be 1 for remote 1. Note: All remotes can be left at the default '4' if not using
ACM.
2
3
1
8-55
Advertisement
Table of Contents
