Test Plan - Teledyne QMultiFlex-400 Installation And Operating Handbook

QMultiFlex-400™ Installation and Operating Handbook
VLAN Definitions
VLAN1: 10.0.70.0 / 16 (M&C VLAN)
VLAN10: 192.168.10.0 / 24 | Gateway: 192.168.10.1
VLAN20: 192.168.20.0 / 24 | Gateway: 192.168.20.1
VLAN30: 192.168.30.0 / 24 | Gateway: 192.168.30.1
8.8.2

Test Plan

The parameters in this test plan are designed for testing in a lab environment and therefore
the IF band (50MHz to 100Mhz) has been selected. The RF details can be modified to suit
your preference.
This is the MODCOD / RF scheme used in this example:
Frequency
Mode
(MHz)
70 DVBS2X
Table 8-7 QMultiFlex-400™ Outbound
Demod Frequency
# (MHz)
1 73.5
2 74.5
3 75.5
Table 8-8 QMultiFlex-400™ Inbounds
The RF cables are organized like the following:
QMultiFlex-400 TX
QFlex-400 TX Remote 1
QFlex-400 TX Remote 2
QFlex-400 TX Remote 3
Modem software above 3.1.40 for hub and remotes was used in this example.
Modulation FEC Rate
32APSK 2/3
Mode Modulation
DVBS2X 8PSK
DVBS2X 8PSK
DVBS2X 8PSK
Combiner
Noise Test Set
Figure 8-33 Cable Connections
8-46
Frame Symbol
Size Rate
Normal 5Msps
FEC Frame Symbol
Rate Size
9/10 Normal 0.5Msps
9/10 Normal 0.5Msps
9/10 Normal 0.5Msps
QFlex-400 RX Remote 1
Splitter
QFlex-400 RX Remote 2
QFlex-400 RX Remote 3
Roll
Off
5%
Roll
Rate Off
20%
20%
20%
QMultiFlex-400 RX