Table of Contents
Advertisement
QMultiFlex-400™ Installation and Operating Handbook
7.1.2
Mesh Network
A mesh network topology is shown in Figure 7-2. In a mesh network there is no hub and
therefore remote-to-remote communications are all single hop. In the simplest case each
site has a single QMultiFlex-400™. In a full mesh each site transmits an outbound to every
site and receives a carrier from every other site.
The Q-NET™ control applications can be located at any site, since each has full visibility
of the whole network. In a partial mesh (where some sites communication requires double
satellite hops) the control applications need to be located at a point that has maximum
network visibility with the least need for double hops.
Figure 7-2 Q-NET™ Mesh Network
7-3
Advertisement
Table of Contents
