Door Installation Onto A Nebs 2000 Frame - Nortel Passport 15000 Hardware Installation And Maintenance

Door installation onto a NEBS 2000 frame

Prerequisites to door installation onto a NEBS 2000 frame
Passport 15000, 20000 Hardware Installation, Maintenance, and Upgrade
Install a door and its mounting hardware onto the front or rear (or both) of a
NEBS 2000 frame to control access to Passport switch hardware or other
equipment.
• "Prerequisites to door installation onto a NEBS 2000 frame" (page 117)
• "Door installation onto a NEBS 2000 frame task flow" (page 122)
• You need one of the following door kits:
— NTQS37AA, which contains 2 doors (NTRU0423), door mounting
hardware (NTRU0192), and the frame extension kit (NTPX4060)
— NTQS37AB, which contains the same contents as NTQS37AA plus
an illuminated brandline cover NTPN53
• You need these tools:
— a step ladder to access the top of the 212.5 cm (7-ft.) NEBS 2000
frame
— a driver to fasten the very large slotted captive screws of the cover as
shown in the figure "Types of screws used with frame enclosure
hardware" (page 120)
— if a frame ground cable needs to be disconnected, a driver for the
very large slotted pan-head screws P0883403 as shown in the figure
"Types of screws used with frame enclosure hardware" (page 120)
and a 10-cm (4-in.) shaft to reach through the bracket to the cable lug
— a driver for a 10-mm (3/8-in.) thread-forming hex-head mounting
screw P0601478 as shown in the figure "Types of screws used with
frame enclosure hardware" (page 120) with a 10-cm (4-in.) reach
past the front of the bracket to the frame uprights as shown in the
figure "Locations of installed brandline covers and top frame
brackets" (page 571)
— a driver to fasten very large Pozidriv screws as shown in the figure
"Types of screws used with frame enclosure hardware" (page 120)
— a driver for a 6-mm (1/4-in.) KEPS nut P0601382
Chapter 9 NEBS 2000 frame accessories 117
5.2S2