Installing An Illuminated Brandline Cover - Nortel Passport 15000 Hardware Installation And Maintenance

Hide thumbs Also See for Passport 15000:

Table of Contents

578 Chapter 17 Hardware procedures

Installing an illuminated brandline cover

Prerequisites

Procedure steps

241-1501-240 5.2S2

Install an illuminated brandline cover onto a top frame bracket at the front or

rear of a NEBS 2000 frame to extend the Passport 15000 or 20000 status

indicators when enclosing the frame with doors.

You must be familiar with "Safety considerations and best practices"

You need these tools:

— a step ladder to access the top of the 212.5 cm (7-ft.) NEBS 2000

— a driver to fasten and unfasten very large slotted captive screws as

shown in the ﬁgure "Types of screws used with frame enclosure

hardware" (page 120)

— a driver to fasten the very large Pozidriv P0600060 screws as shown

in the ﬁgure "Types of screws used with frame enclosure hardware"

— a ﬂashlight to see the connections at the rear of the BIP

The illuminated brandline cover is intended to be installed at the front of

a NEBS 2000 frame, but you can choose to mount it instead at the rear.

The LED cable accommodates installing an illuminated brandline cover

at the front or the rear, but not both simultaneously.

For initial installations of a Passport 20000 in a NEBS 2000 frame, the

LED V-cable NTHW66 is already installed and connected at J3.

Use the ﬁgure "Paths of the LED cable NTHW66 to the front and rear of a

NEBS 2000 frame" (page 581) to determine whether the NTHW66 is

already installed and connected to J3. The cable is labelled.

If it is installed, go to step 4.

If it is not installed, go to step 2.

Route 1 of the 4-pin connectors of the cable NTHW66 from the left rear of

the BIP above J3 to the front of the frame as shown in the side view in the

ﬁgures "Paths of the LED cable NTHW66 to the front and rear of a NEBS

Show Quick Links

Table of Contents

Passport 20000