Installing A Shasta 5000 Filler Panel - Nortel Passport 15000 Hardware Installation And Maintenance

Installing a Shasta 5000 filler panel
Prerequisites
Procedure steps
Passport 15000, 20000 Hardware Installation, Maintenance, and Upgrade
Install a Shasta 5000 filler panel to maintain proper air flow through the
NEBS 2000 frame and to comply with NEBS 2000 equipment containment.
• You must be familiar with "Safety considerations and best practices"
(page 53).
• You will need a filler panel with part number P0914657, from the
hardware kit NTHW85.
1 Unpack the filler panel.
2 Position the filler panel between the frame uprights below the breaker
interface panel (BIP) and above the cable management assembly. See
the figure "Location of the filler panel for a Shasta 5000 in a NEBS 2000
frame" (page 500).
3 Using four 10-mm (3/8-in.) screws, fasten the filler panel to the frame
uprights.
4 Tighten all screws to snug plus a 1/4-turn.
Chapter 17 Hardware procedures 499
5.2S2