Nortel Passport 15000 Hardware Installation And Maintenance page 613

9 From the kit NTRU0366, align a lower bracket (P0902815) according to
the figure "Lower brackets for frame panels" (page 616).
10 Fasten the bracket to the kick plate using the 2 provided 6-mm screws.
11 Repeat step 6 and step 7 for the other 3 lower brackets.
12 Hold a panel (P0902812) so that
• the smooth surface faces you
• the end hole is at the top
• the two tabs are at the bottom
13 Place the two tabs into the slots in a lower bracket and swing the panel
against the upper bracket.
14 Align the screw hole on the panel with the hole in the upper bracket and
fasten a large-slotted screw through them both. Hand tighten the screw to
snug plus a 1/5 turn.
15 Repeat step 12 to step 14 for the remaining panels so that 2 are installed
on the front of the frame and 2 on the rear.
16 Fasten the filler (P0902816) as shown using the 2 provided thread-
forming 6-mm (15/64-in.) hex-head screws.
Passport 15000, 20000 Hardware Installation, Maintenance, and Upgrade
Chapter 17 Hardware procedures 613
5.2S2