Nortel Passport 15000 Hardware Installation And Maintenance page 520

520 Chapter 17 Hardware procedures
Procedure job aids
Figure 188
Assembly of a side panel bracket NTRU0371, left and right, upper or lower
241-1501-240 5.2S2
8 Align and loosely fasten a screw and washer through each of the
remaining 6 panel holes, starting at a bottom corner.
9 If a door was installed, check for gaps or significant misalignment
between the nearest edge of the door and the panel. You can slightly re-
position the panel to align with the door.
10 Tighten all screws to snug plus a 1/4 turn.
11 Lightly tap a plastic cap onto each special washer. Installed side panels
are shown in the figure "Installed extended side panels with a door"
(page 522).
PPT 2821 011 AC2