Nortel Passport 15000 Hardware Installation And Maintenance page 722

Hide thumbs Also See for Passport 15000:

Table of Contents

722 Chapter 17 Hardware procedures

241-1501-240 5.2S2

On the outside face of the ﬁller panel mounting ears, determine whether

any cable management bracket shares screws with the panel. Refer to the

ﬁgure "Physical characteristics of a front shelf ﬁller panel" (page 723). If

you cannot access the 2 screws of each bracket without stressing the

cables that are fastened to it, you must unfasten the cables from the

The ﬁller panel also has cuts in each mounting ear to surround cable

management brackets without sharing the bracket screws.

For any bracket or pair of brackets that shares screws with the ﬁller panel,

note the position and orientation of each bracket. Unfasten the 10-mm

(3/8-inch) screws, remove the bracket, and put them aside temporarily.

Unfasten the remaining screws of the ﬁller panel. When unfastening the

last 2 screws of the ﬁller panel, have the helper hold the panel to prevent

it from falling.

If the opposite ﬁller panel was removed, install it back where it was.

If the ﬁller panel is not being replaced, you must either

re-install the equipment that formerly shared mounting screws with

the ﬁller panel, especially since a termination panel should not be

operated while it is unmounted

install the equipment somewhere else because a second shelf is

being installed where the ﬁller panel was

10 If the ﬁller panel is not being replaced, you must re-install the cable

management brackets and fasten the cables back onto them.

Show Quick Links

Table of Contents

Passport 20000