Replacing A Cable Management Channel Cover - Nortel Passport 15000 Hardware Installation And Maintenance

Replacing a cable management channel cover

Prerequisites
Procedure steps
Passport 15000, 20000 Hardware Installation, Maintenance, and Upgrade
Replace a cable management channel cover to restore protection to FP
interface cables.
• You must be familiar with "Safety considerations and best practices"
(page 53).
• The cable management channel cover spans the width of the cage, and
covers the CP and the FP cables. See the figure "Location of cable
management channel covers, lower shelf" (page 786).
1 Unlock the channel cover by turning the slotted lock counterclockwise. Do
not use a power tool.
2 Swing the top of the cover out and towards you until it rests horizontally.
3 Disengage the hinge pins at opposite ends of the cover by gently bending
the middle of the flat side of the cover towards yourself until one pin is free.
Put the cover aside.
4 Engage the hinge pins of the replacement cover.
5 Swing the top of the cover towards the shelf until it rests against the
slotted latch plate.
6 Align the lock through the slotted latch plate and turn the slotted screw
gently clockwise. Do not use a power tool.
Chapter 17 Hardware procedures 785
5.2S2