Installing A Door Hinge Onto The Upper Left Of A Frame - Nortel Passport 15000 Hardware Installation And Maintenance

Hide thumbs Also See for Passport 15000:

Table of Contents

430 Chapter 17 Hardware procedures

Installing a door hinge onto the upper left of a frame

Prerequisites

Procedure steps

241-1501-240 5.2S2

Install a door hinge onto the upper left front or rear of a NEBS 2000 frame to

enable opening a door.

You must be familiar with "Safety considerations and best practices"

You need a door hinge from kit NTRU0192 as shown in the ﬁgure "An

upper door hinge P0884031" (page 414) and two of the extension

brackets that are shown in the ﬁgure "An extension mounting bracket

P0995495" (page 424). The extension brackets are already installed on

the front of the frame from another procedure, but may not be on the rear.

You need 4 Pozidriv screws P0600060 and 4 lock washers P0600895

from kit NTPX4060 as shown in the ﬁgure "Types of screws used with

frame enclosure hardware" (page 120).

Loosely fasten 4 Pozidriv 12-mm screws P0600060 each with a lock

washer P0600895 through an extension mounting bracket P0995495 to

the left side of the top frame bracket as shown in the ﬁgure "Orientation of

an upper door hinge and an extension bracket" (page 397).

Align the holes of the hinge with the holes on the left side of the extension

bracket as shown in the ﬁgure.

Loosely fasten the door hinge to the top frame bracket using 4 Pozidriv

12-mm screws P0600060 each with a lock washer P0600895. Drive the

screws from the direction shown in the ﬁgure.

Tighten all screws to snug plus a 1/4 turn.

Show Quick Links

Table of Contents

Passport 20000