Installing A Door Hinge Onto The Lower Left Of A Frame - Nortel Passport 15000 Hardware Installation And Maintenance

Hide thumbs Also See for Passport 15000:

Table of Contents

426 Chapter 17 Hardware procedures

Installing a door hinge onto the lower left of a frame

Prerequisites

Procedure steps

241-1501-240 5.2S2

Install a door hinge onto the lower left front or rear of a NEBS 2000 frame to

enable opening a door.

You must be familiar with "Safety considerations and best practices"

You need a door hinge from kit NTRU0192 as shown in the ﬁgure "A

lower door hinge P0884947" (page 412) and the lower left extension

bracket P0995494 that is the opposite of the ﬁgure "A lower right

extension bracket P0995493" (page 404). The lower left extension

bracket is already installed onto the base of the NEBS 2000 frame from

another procedure.

You need 4 Pozidriv screws P0600060 and 4 lock washers P0600895

from kit NTPX4060as shown in the ﬁgure "Types of screws used with

frame enclosure hardware" (page 120).

Align the holes of the hinge with the holes on the outside of the lower left

extension bracket as shown in the ﬁgure "Orientation of a cosmetic ﬁller,

a lower door hinge, and a lower left extension bracket" (page 406).

Loosely fasten the door hinge through the extension bracket using 4

Pozidriv 12-mm screws P0600060 each with a lock washer P0600895.

Drive the screws from the direction shown in the ﬁgure.

Tighten all screws to snug plus a 1/4 turn.

Show Quick Links

Table of Contents

Passport 20000