Nortel Passport 15000 Hardware Installation And Maintenance page 309

• the exposed wires stop at the bottom of the screw hole
• the edge of cut insulation is flush with the top of the terminal block;
you may have to strip more insulation or shorten the wires
10 Remove the cable and coat the exposed wire with anti-oxidizing grease,
unless your local electrical codes specify otherwise.
11 Insert the cable back into the top opening in the block.
12 Fasten the screw back into its opening until it firmly clamps the end of the
cable. The cable sheath must be flush against the block so that no wire is
exposed.
13 For each remaining power cable, repeat step 2 to step 12. Identify the
next cable by its label according to the figure "Overhead power input
cables for the lower shelf connected to the BIP" (page 337).
Passport 15000, 20000 Hardware Installation, Maintenance, and Upgrade
Chapter 17 Hardware procedures 309
5.2S2