292 Chapter 17 Hardware procedures
Procedure job aid
Figure 77
MT-RJ fiber connector
Fiber endface
Receive
241-1501-240 5.2S2
7
Blow dry the ferrule end with clean-room grade air. Do not blow breath or
use in-house air to dry the ferrule.
8
Assess the cleanliness of the ferrule endface through an appropriate
microscope.
If it is not satisfactory, repeat steps 2 through 7.
If it is satisfactory, replace the dust cap on the connector or immediately
plug the connector to an adapter or a transceiver that has already been
cleaned.
Front view
Side view
Connector guides
Transmit
PPT 2924 002 AA