Connecting The Mx480 To Power; Tools And Parts Required For Mx480 Router Grounding And Power; Connections; Figure 70: Installing The Cable Management Brackets - Juniper MX480 Hardware Manual

Connecting the MX480 to Power

Tools and Parts Required for MX480 Router Grounding and Power Connections
Copyright © 2019, Juniper Networks, Inc.

Figure 70: Installing the Cable Management Brackets

Slot
Tab

Tools and Parts Required for MX480 Router Grounding and Power

Connections on page 203
Grounding the MX480 Router on page 204
Connecting Power to an AC-Powered MX480 Router with Normal-Capacity Power
Supplies on page 205
Powering On an AC-Powered MX480 Router on page 206
Connecting Power to a DC-Powered MX480 Router with Normal Capacity Power
Supplies on page 207
Powering On a DC-Powered MX480 Router with Normal Capacity Power
Supplies on page 210
Powering Off the MX480 Router on page 212
Connecting an MX480 AC Power Supply Cord on page 212
Connecting an MX480 DC Power Supply Cable on page 213
To ground and provide power to the router, you need the following tools and parts:
Phillips (+) screwdrivers, numbers 1 and 2
2.5-mm flat-blade (-) screwdriver
7/16-in. (11 mm) hexagonal-head external drive socket wrench, or nut driver, with a
torque range between 23 lb-in. (2.6 Nm) and 25 lb-in. (2.8 Nm), for tightening nuts to
terminal studs on each power supply on a DC-powered router.
Chapter 3: Initial Installation and Configuration
Screws
203