Installing An Mx480 As Mxc; Figure 134: Removing An As Mxc - Juniper MX480 Hardware Manual

See Also
Copyright © 2019, Juniper Networks, Inc.

Figure 134: Removing an AS MXC

MX480 Application Services Modular Processing Card Description on page 133

Installing an MX480 AS MXC

To install an AS MXC (see
Attach an ESD grounding strap to your bare wrist and connect the strap to one of the
1.
ESD points on the chassis.
Align the notches in the connector at the rear of the AS MXC with the notches in the
2.
AS MXC slot (slot 1—the bottom slot in the AS MLC), and then slide the AS MXC in
until it lodges firmly in the AS MLC.
CAUTION: Slide the AS MXC straight into the slot to avoid damaging the
components on the bottom of the AS MXC.
Use one of the following methods to bring the AS MXC online:
3.
Press the AS MXC offline/online button until the LED light turns green.
Issue the following CLI command:
Figure 135 on page 316):
Chapter 4: Maintaining Components
315